OBD 2 Splitter Adapter Extension Cable for Launch scanner CReader 3001 Male To Female cable.
OBD2 Adapter cable Red and Yellow Extension Cable:
SAE J1962 defines the pinout of the connector as:
Splitter Male to female . That is your car telling you there is an issue. If you visit a mechanic, he will use an OBD2 scanner to diagnose the issue. To do so, he will connect the OBD2 reader to the OBD2 16-pin connector near the steering wheel.
Features of Obd2 Scanner Male to Female Car Scanner Extension Cable:
It is also a Brand new and high-quality OBD-II Male OBD extender, obd2 extension cable, and OBD-II Female Flat Cable.
It is also used for connecting your diagnostic interface moreover your vehicle with OBD-II compliant.
Length: About 60 cm.
Weight: 282 gm.
OBD-II Plug: 16-pin male to the car.
It is also used for diagnostic Flat OBD-II Male -OBD-II Female Cable Diagnostic Cable Engine Company Vehicles.
Cable core: 16 Core.
OBD Connector Pinout Configuration.
|These pins are not standard and are vendor-specific. It also not required for normal communication/interfacing
|SAE J1850 Bus+
|This protocol uses Variable Pulse Width and is normally used by GM vehicles. It also Buses positive pin of the protocol.
|SAE J1850 Bus-
|This protocol uses Variable Pulse Width and is normally used by GM vehicles. It also Buses a negative pin of the protocol.
|The ground of the complete system of the Car including the chassis
|ISO15765-4 CAN High
|It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN high Pin.
|ISO15765-4 CAN Low
|It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN low Pin.
|ISO 9141 – K Line
|It follows an asynchronous serial communication protocol. It also has Kline pin.
|ISO 9141 – L Line
|It follows an asynchronous serial communication protocol. It also has an L-line pin.
Package Included 1 x OBD-II Male to OBD-II Female Flat Cable.