Sale!

511

1) Colour-Black.
2) 16 Pin OBD-II Female Connector.
3)Great for DIY And Homemade Projects.
4)16 Pin female Connector.
5)Small & High-Quality Products.

Description

OBD-II Female ECU Pressfit Connector :

Female OBD-II connector on a car Female OBDII Male Connector 16 PIN pinout – front view The OBD-II specification provides for a standardized hardware interface—the female 16-pin (2×8) J1962 connector. Unlike the OBD-I connector, which was sometimes found under the hood of the vehicle, the OBD-II Male Connector 16 PIN  connector is required to be within 2 feet (0.61 m) of the steering wheel (unless an exemption is applied for by the manufacturer, in which case it is still somewhere within reach of the driver). SAE J1962 defines the pinout of the connector as:

What is an OBD2  Connector?

OBD stands for Onboard Built-in Diagnosis. As the name suggests it is a diagnosis system that is built into all modern cars (after 1996) which has a computer based application that monitors the performance of your car through your speed, mileage, fuel emission data etc.. Apart from this it also measures some of the important vital parameters of an Engine. This complete system is called as an ECU (Engine Control Unit).

 

OBD-II Female ECU Pressfit Connector Pinout Configuration

Pin Number Pin Name Description
1,3,8,9,11,12,13 Blank These pins are not standard and are vendor specific. It is also not required for normal communication/interfacing
2 SAE J1850 Bus+ This protocol uses Variable Pulse Width and is normally used by GM vehicles. This is the Bus positive pin of the protocol.
10 SAE J1850 Bus- This protocol uses Variable Pulse Width and is normally used by GM vehicles. This is the Bus negative pin of the protocol.
4,5 Ground Ground of complete system of the Car including chassis
6 ISO15765-4 CAN High It follows 2-wire CAN protocol at 1Mbps speed. This is the CAN high Pin
14 ISO15765-4 CAN Low It follows 2-wire CAN protocol at 1Mbps speed. This is the CAN low Pin
7 ISO 9141 – K Line It follows asynchronous serial communication protocol, this pin is the K line
8 ISO 9141 – L Line It follows asynchronous serial communication protocol, this pin is the L line

OBD-II Female ECU Pressfit Connector Warrenty : NA