OBD 2 Splitter Adapter Extension Cable for Launch scanner CReader 3001 Male To Female cable.
OBD2 Adapter cable Red and Yellow Extension Cable:
SAE J1962 defines the pinout of the connector as:
Splitter Male to female . That is your car telling you there is an issue. If you visit a mechanic, he will use an OBD2 scanner to diagnose the issue. To do so, he will connect the OBD2 reader to the OBD2 16-pin connector near the steering wheel.
Features of Obd2 Scanner Male to Female Car Scanner Extension Cable:
It is also a Brand new and high-quality OBD-II Male OBD extender, obd2 extension cable, and OBD-II Female Flat Cable.
It is also used for connecting your diagnostic interface moreover your vehicle with OBD-II compliant.
Length: About 60 cm.
Weight: 282 gm.
OBD-II Plug: 16-pin male to the car.
It is also used for diagnostic Flat OBD-II Male -OBD-II Female Cable Diagnostic Cable Engine Company Vehicles.
Cable core: 16 Core.
OBD Connector Pinout Configuration.
|Pin Number||Pin Name||Description|
|1,3,8,9,11,12,13||Blank||These pins are not standard and are vendor-specific. It also not required for normal communication/interfacing|
|2||SAE J1850 Bus+||This protocol uses Variable Pulse Width and is normally used by GM vehicles. It also Buses positive pin of the protocol.|
|10||SAE J1850 Bus-||This protocol uses Variable Pulse Width and is normally used by GM vehicles. It also Buses a negative pin of the protocol.|
|4,5||Ground||The ground of the complete system of the Car including the chassis|
|6||ISO15765-4 CAN High||It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN high Pin.|
|14||ISO15765-4 CAN Low||It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN low Pin.|
|7||ISO 9141 – K Line||It follows an asynchronous serial communication protocol. It also has Kline pin.|
|8||ISO 9141 – L Line||It follows an asynchronous serial communication protocol. It also has an L-line pin.|
Package Included 1 x OBD-II Male to OBD-II Female Flat Cable.