OBD2 Extension cable OBD II OBD2 16 Pin Splitter T Splitter OBD Cable
OBD2 Extension cable OBD II OBD2 16 Pin Splitter T Splitter is also an improvement over OBD-II in both capability and standardization. This Cable OBDII Connector standard specifies the type of diagnostic connector and its pinout, the electrical signaling protocols available, and the messaging format. It also provides a candidate list of vehicle parameters to monitor along with how to encode the data for each. There is also a pin in the connector that provides power for the scan tool from the vehicle battery, which eliminates the need to connect a scan tool to a power source separately.
In Cable Information of OBD2 Connector :
It also has a Female OBD-II connector on a car Female OBD Connector connector pinout – front view The OBDII specification provides for a standardized hardware interface—the female 16-pin (2×8) J1962 connector. Unlike the OBD-I connector, which was sometimes found, under the hood of the vehicle, the OBD-II connector is required to be within 2 feet (0.61 m) of the steering wheel.
SAE J1962 defines the pinout of the connector as:
The amount of diagnostic information available via T-Splitter OBD-II Male to 2 OBD-II Female Cable OBDII has varied widely since its introduction in the early 1980s versions of on-board vehicle computers.
That is your car telling you there is an issue. If you visit a mechanic, he will use an OBD2 scanner to diagnose the issue.
To do so, he will connect the OBD reader to the OBD2 16-pin connector near the steering wheel.
This lets him read OBD codes aka Diagnostic Trouble Codes (DTCs) to review and troubleshoot the issue.
Features of OBD2 Extension cable:
It is also a Brand new and high-quality OBD-II cable.
For connecting your diagnostic interface and your vehicle with OBD-II compliant.
Length: About 200cm.
OBD-II Plug: 16-pin male to the car.
Mostly Used for diagnostic T-Splitter OBD-II Male to 2 OBD-II Female Cable Engine Company Vehicles.
Cable core: 8 Core.
In Splitter Obd diagnostic Cable OBD Connector Pinout Configuration
|Pin Number||Pin Name||Description of OBD2 Extension cable|
|1,3,8,9,11,12,13||Blank||These pins are not standard and are vendor-specific. It is also not required for normal communication/interfacing|
|2||SAE J1850 Bus+||Likewise, This protocol uses Variable Pulse Width and is normally used by GM vehicles. This is the Bus positive pin of the protocol.|
|10||SAE J1850 Bus-||This protocol uses Variable Pulse Width and is normally used by GM vehicles. This is the Bus negative pin of the protocol.|
|4,5||Ground||Likewise, The ground of complete system of the Car including chassis|
|6||ISO15765-4 CAN High||it follows a 2-wire CAN protocol at 1Mbps speed. It also CAN high Pin|
|14||ISO15765-4 CAN Low||a 2-wire CAN protocol at 1Mbps speed. It also CAN low Pin|
|7||ISO 9141 – K Line||an asynchronous serial communication protocol. It also Kline Pin|
|8||ISO 9141 – L Line||It also follows the same as pin no 7, this pin is the L line|
It is also Compatible with diagnostic tools with a 16 pin socket. also Universal for all cars with OBD-II Interface. Cable Length: 2 Meter, Cable Core: 8