Sale!

1170

Key Points

  • OBD-II to DB15 Male Cable for Mahindra
  • Brand New & High Quality
  • Cable Core-16
  • Length-2 mtr
  • Weight-204 gm
LIMITED OFFER!

Description

Ismart Mahindra OBD-II cable

Ismart Mahindra OBD-II cable. OBD Connector degree is an improvement over OBD-II in both capability and standardization.

The OBDII Connector standard specifies the type of diagnostic connector and its pinout.

Universal OBD2 Connector:

OBD2

That is your car telling you there is an issue. If you visit a mechanic, he will use an OBD2 scanner to diagnose the issue.

To do so, he will connect the OBD2 reader to the OBD2 16 pin connector near the steering wheel.

This lets him read OBD2 codes aka Diagnostic Trouble Codes (DTCs) to review and troubleshoot the issue.

 In Ismart Mahindra OBD-II cable OBD2 Connector Pinout Configuration

Pin Number Pin Name Description
1,3,8,9,11,12,13 Blank These pins are not standard and are vendor-specific. It  also not required for normal communication/interfacing
2 SAE J1850 Bus+ This protocol uses Variable Pulse Width and is normally used by GM vehicles. It also  Bus positive pin of the protocol.
10 SAE J1850 Bus- This protocol uses Variable Pulse Width and is normally used by GM vehicles.  It also  Bus negative pin of the protocol.
4,5 Ground The ground of complete system of the Car including chassis
6 ISO15765-4 CAN High It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN high Pin
14 ISO15765-4 CAN Low It follows a 2-wire CAN protocol at 1Mbps speed. It also CAN low Pin
7 ISO 9141 – K Line It follows asynchronous serial communication protocol, It also Kline Pin
8 ISO 9141 – L Line It follows asynchronous serial communication protocol, It also L line Pin

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.